Today's Day & Date: Wednesday the 21st of April 2021.
I am currently awaiting to receive confirmation from the two below-mentioned component & service suppliers for the New Steam Car project, that they can provide to me the below-mentioned
required highly specialised components & services:
(1). The Professional custom design only of the proprietary highly specialised five in total micro steam turbine assemblies (i.e., steam engines) for one of the new steam cars. One of the 'larger
size' steam turbine assembly independently all by itself direct drives one of the four road wheels, with no conventionally fuelled engine, no hydrogen, no electric motor or no electric motors used for the propulsion system, no transmission or no gearbox (whether
a manual or an automatic transmission or gearbox), no final drive or no differential unit & no tail shaft assembly used for their individual separate functionalities.
This equates to four 'larger size' micro steam turbine assemblies (i.e., steam
engines) in total, with each one strategically positioned & mounted at each one of the four road wheel assemblies, used for each one of the new steam cars. The final fifth 'smaller size' micro steam turbine assembly (i.e., steam engine) direct drives (by
way of an interconnected small drive flange gear pulley & interconnected rubber ribbed drive belt), the one 48 DC Volt very high amperage output capacity electrical charging alternator (i.e., for one steam car), so as to recharge a depleted or a discharged
battery condition. This final 'smaller size' micro steam turbine assembly (i.e., steam engine) is positioned & mounted at the front & centre of the new steam car, directly behind the condenser of the air conditioning system. This particular 'one of
a kind' professional Company Organisation is based & located in Italy Europe.
(2). A professional accredited & suitably experienced Electronics Engineer to design the complete Electrical System for the Electrically Operated Automotive
Passenger Motor Vehicle prototype, if & as is necessary for the Electrically Operated Electricity Producing Steam Engine Assembly prototype, by travelling on-site to correctly wire up all electrical circuits, electrical alternators & the electrically
operated heater & air-conditioning system etc & connect all components from the steam engine assemblies & the prototype to the test battery banks & correctly compile an electrical data specification presented to the custom
designer, manufacturer & component supplier of the 48 DC Volt Engine Management System (EMS) or onboard computer & Digital Dashboard Assembly, located in Victoria Australia showing the operating voltages, amps & amp hours (ah)
required for the satisfactory operation of the electrically operated motor vehicle prototype. This electrical data specification is also presented to the custom designer, manufacturer & component supplier of the 48 DC Volt Lithium-Ion
or similar battery material battery for the purpose to be made into a suitable specialised battery pack for the above-mentioned new Automotive Motor Vehicle. Also, the electrical data specification if & as required, is to be utilised for a battery or battery
pack to suit the new ENERGY - Electrically Operated Self Propelled Steam Powered Electricity Producing Steam Boiler & Steam Turbine Steam Engine Assembly. This particular 'one of a kind' professional Company Organisation is based & located in
Upon these confirmations, from the above-mentioned two-component & service suppliers, they will be noted & highlighted here within this very special 'Additional Centrepiece Section,' solely because of their complete overall
supreme prowess, skill & competence in the very large scope of the requested requirements in being able to provide to me what I require of them for the new steam car project, which greatly exceeds all
other requested requirements within the entire component & service suppliers for the new steam car project.
**(Soon to be advised & announced here)**
My Best Regards
Craig E. Whittington
(Sydney New South Wales (NSW) Australia).